Avaya callpilot 1002rp, Maintenance And Diagnostics

Page: 32 / 150

How tracert works
The tracert utility follows several steps to complete its task:
• Tracert sends Internet Control Message Protocol (ICMP) echo packets with varying Time-
To-Live (TTL) values to the destination.
• Each router along the path must decrement the TTL on a packet by at least 1 before
forwarding it, so the TTL is effectively a hop count.
• When the TTL on a packet reaches 0, the router sends back an ICMP Time Exceeded
message to the source system.
• Tracert determines the route by sending the first echo packet with a TTL of 1, and
incrementing the TTL by 1 on each subsequent transmission until the target responds, or
the maximum TTL is reached.
• Tracert then examines the ICMP Time Exceeded messages sent back by intermediate
routers.
Tracert syntax
The tracert command uses the following syntax:
tracert [-d] [-h maximum_hops] [-j host_list] [-w timeout]
[target_name]
Tracert parameters
the following table shows the tracert parameters.
Table 5: Tracert parameters
Parameter Description
-d Specifies not to resolve addresses to hostnames.
-h maximum_hops Specifies the maximum number of hops to search for the target.
-j host-list Specifies a loose source route along the host list.
-w timeout Waits the number of milliseconds specified by the timeout for
each reply.
Using Windows online diagnostic tools
32 Avaya CallPilot® 1002rp Server Maintenance and Diagnostics December 2010