Installation,
Wiring,
and
Specifications
2--29
Installation, Wiring, and Specifications
DL105 PLC User Manual, 3rd Edition
Wiring Diagrams and Specifications
The remainder of this chapter dedicates two to three pages to each of the eight
versions of DL105 Micro PLCs. Each section contains a basic wiring diagram,
equivalent I/O circuits, and specification tables. Please refer to the section which
describes the particular DL105 version used in your application.
The F1--130AR Micro PLC features ten AC inputs and eight relay contact outputs.
The following diagram shows a typical field wiring example. The AC external power
connection uses three terminals at the top left as shown.
Output Point Wiring
Ground
Neutral
Line
Power
Input Wiring
Input Point Wiring
+
--
to field
AC or DC
Supply
Equivalent Input Circuit
Optical
Common
Input
+V
Isolator
To other circuits in bank
AC or DC
Supply
Equivalent Output Circuit
To other circuits in bank
Common
Output
+V
devices
Derating Chart for Relay Outputs
0
2
4
6
8
Points
0
10
20
30
40
50
60
Ambient Temperature (
C/
F)
32
50
68
86
104
122
140
C
F
7A
AC or DC
Supply
6A
7A
Fuse or
C.B.
Fuse
or
C.B.
The ten AC input channels use terminals on the bottom connector. This input type
also works for high-voltage DC signals. Inputs are organized into two banks of four,
plus one bank of two. Each bank has a common terminal. In the case of DC input
signals, the input may be wired in as either the sourcing or sinking type. The wiring
example above shows all commons connected together, but separate supplies and
common circuits may be used. The equivalent input circuit shows one channel of a
typical bank.
The eight relay output channels use terminals on the top connector. Outputs are
organized into four banks of two normally-open relay contacts. Each bank has a
common terminal. The wiring example above shows all commons connected
together, but separate supplies and common circuits may be used. The equivalent
output circuit shows one channel of a typical bank. The relay contacts can switch AC
or DC voltages.
F1--130AR
I/O Wiring Diagram
Summary of Contents for DL105
