Atmel ATmega128, Manual

Page: 373 / 386

373
2467S–AVR–07/09
ATmega128
Datasheet
Revision
History
Please note that the referring page numbers in this section are referred to this document. The
referring revision in this section are referring to the document revision.
Rev. 2467S-07/09
1. Updated the “Errata” on page 371 .
2. Updated the TOC with the newest template (version 5.10).
3. Added note “Not recommended from new designs“ from the front page.
4. Added typical I
CC
values for Active and Idle mode in “DC Characteristics” on page
318 .
Rev. 2467R-06/08
1. Removed “Not recommended from new designs“ from the front page.
Rev. 2467Q-05/08
1. Updated “Preventing EEPROM Corruption” on page 25 .
Removed sentence “If the detection level of the internal BOD does not match the needed
detection level, and external low V
CC
Reset Protection circuit can be used.“
2. Updated Table 85 on page 197 in “Examples of Baud Rate Setting” on page 194 .
Remomved examples of frequencies above 16 MHz.
3. Updated Figure 114 on page 238 .
Inductor value corrected from 10 mH to 10 µH.
4. Updated description of “Version” on page 253 .
5. ATmega128L removed from “DC Characteristics” on page 318 .
6. Added “Speed Grades” on page 320 .
7. Updated “Ordering Information” on page 368 .
Pb-Plated packages are no longer offered, and the ordering information for these packages
are removed.
There will no longer exist separate ordering codes for commercial operation range, only
industrial operation range.
8. Updated “Errata” on page 371 :
Merged errata description for rev.F to rev.M in “ATmega128 Rev. F to M” .
Rev. 2467P-08/07
1. Updated “Features” on page 1 .
2. Added “Data Retention” on page 8 .
3. Updated Table 60 on page 134 and Table 95 on page 235 .
4. Updated “C Code Example(1)” on page 177 .
5. Updated Figure 114 on page 238 .