38
Remove the spark plug connector.
Remove the spark plug.
Then fill a little amount of engine oil (approx. 5-10 ml) into the cylinder.
Slowly pull out the cranking
rope handle to distribute the oil.
Re-mount the spark plug.
Before any use of the device you have to remove and clean the spark plug.
Please refer to the ”Engine Operating Instructions“ for more information on storing the engine.
Check the machine for perfect condition to ensure a safe use of it after a longer period of storage.
P
P
o
o
s
s
s
s
i
i
b
b
l
l
e
e
p
p
r
r
o
o
b
b
l
l
e
e
m
m
s
s
Fault
Possible cause
Remedy
Engine does not start.
Engine cold.
Choke lever set to “
Position
“
Set choke lever to “
Position
“
Throttle lever put to
.
Put throttle lever to
.
Ignition switch put to
OFF
.
Put ignition switch to
ON
.
Fuel valve put to „
OFF
“.
Put fuel valve to „
ON
“.
No fuel supply
Check the fuel quantity
Fuel old or contaminated.
Drain the fuel into a container outdoors.
Fill the
tank with fresh and clean fuel.
Fault in the fuel line
Check the fuel line for kinks or damages
Spark plug connector not placed on.
Place on the spark plug connector.
No ignition spark.
a) Clean or replace the spark plug.
b) Check the ignition cable.
c) Fault cannot be eliminated?
Get the manufacturer or authorised service
staff to check the ignition system.
Engine flooded.
Screw off, clean and dry the spark plug. Then pull
the cranking rope several times and reinstall the
spark plug.
Carburettor defective
Contact the manufacturer or the responsible
customer service respectively.
Engine defective.
Replace the engine.
Internal fault.
Contact the manufacturer or the responsible
customer service respectively.
Engine is sputtering.
(runs erratically)
Choke lever set to “
Position
“
Set choke lever to “
Position
“
Spark plug connector not firmly placed on. Firmly place on the spark plug connector.
Vent in the tank cap blocked.
Clean the tank cap and the vent.
Fuel old or contaminated.
Drain the fuel into a container outdoors.
Fill the
tank with fresh and clean fuel.
Incorrect carburetor adjustment.
Have the caburetor adjusted correctly. (customer
service)
Decreasing engine power.
Machine overloaded.
a) Reduce material feeding.
b) Do not exceed the max. branch diameter.
Air filter contaminated.
Clean or replace filter elements
Logs are not being split properly
(insufficient splitting performance).
The log is not positioned correctly.
The log exceeds the maximum
dimensions or the wood is too hard for
the performance of the machine.
Splitting blade does not split log.
Hydraulic pressure too low.
Release rods bent (hydraulic tappet not
quite pressed in).
Reposition the log correctly.
Cut the log to the required dimensions.
Sharpen splitting blade, check for burrs or
notches.
Check the oil level and add more oil if
necessary.
If the problem cannot be rectified, refer to the
manufacturer or other approved service
centre.
Arrange for manufacturer or authorised
company to adjust the rods.
