Getting Started
QL-850 User Guide
29
Working with Reflective Mark Media
Reflective mark media may require special handling to ensure proper top-of-form calibration.
Observe the following guidelines when using reflective mark media.
•
Ensure the reflective mark meets the width, length, and density requirements.
•
Before loading media, ensure that the leading edge of the media contains no reflective
mark within the first ¼ inch from the cut edge. If any part of the reflective mark is within
this area, cut the media directly behind the mark removing the entire mark but as little of
the unmarked liner as possible. Then the media can be loaded into the printer without
concern for a poor top-of-form calibration.
•
If necessary, adjust the vertical offset in the printer driver. Also make sure the reflective
sensor type is selected. Refer to the QL-850 Driver Help for details.
Summary of Contents for QuickLabel QL-850
Page 1: ...U S E R G U I D E...
