Getting Started
QL-850 User Guide
25
16.
Open the top cover and verify that ink has filled all of the five tubes shown below.
Caution: If ink is not visible in all of the indicated tubes, contact Technical Support. Do
not run the After Shipping Wizard in the QL-850 Maintenance Utility again or an ink
overflow may occur.
17.
Close the top cover.
Loading and Unloading Media
Loading Media
Note: If you are using gap media with wide gaps between labels, special handling instructions
may apply.
See “Working with Wide Gap Media” on page 28.
1.
Turn the wing nut [1] on the end of the mandrel counterclockwise to loosen the mandrel.
2.
Loosen the fastener on the outer flange [4]. Then remove the outer flange from the
mandrel.
3.
Orient the media roll [2] as illustrated and put it on the mandrel. Make sure the roll makes
contact with the inner flange [3].
4.
Turn the wing nut [1] on the end of the mandrel clockwise until you feel resistance. This
secures the roll in place.
5.
Put the outer flange [4] on the mandrel. Make sure the outer flange makes contact with
the roll [2].
6.
Tighten the fastener on the outer flange [4] until you feel resistance. This secures the
outer flange in place.
[1]
[2]
[4]
[3]
[5]
Summary of Contents for QuickLabel QL-850
Page 1: ...U S E R G U I D E...
