Rewinder
QL-850 User Guide
106
5.
Load an empty label core on the mandrel.
Use an empty label core of the same width as the label media you will be using. Install
the roll core on the rewinder, sliding it until it contacts the inner flange [1]. The outer flange
[2] will be installed after you fasten the label media to the roll core.
6.
Start a print job. Pause the job when the printed media advances slightly past the
rewinder.
7.
Guide the media under the rewinder dancer arm [5] and up around the empty label core.
The inside edge of the media should be aligned squarely with the inner flange [1].
If the media is not squarely aligned with the inner flange, adjust the position of the
rewinder as needed.
•
Loosen the thumb screws that fasten the rewinder to the bracket. Slide the
rewinder left/right as allowed by the adjustment slots until the media is squarely
aligned with the inner flange. Then tighten the thumb screws.
8.
Fasten the end of the media to the core with tape. Ensure the printed side faces out.
9.
Reinstall the outer flange [2] and then turn the mandrel adjustment knob [4] clockwise to
tighten the mandrel.
10.
Install the removable roll support arm [7]. Then tighten the thumb screw [6] to lock it into
position.
11.
Turn the power switch [3] on the rewinder to the on position.
When the dancer arm is in a lowered position, the rewinder mandrel will rewind media as
needed. Do not turn the mandrel by hand to rewind the media. The media rewind path is
illustrated below.
12.
Resume the print job on the QL-850 printer. The rewinder will rewind media automatically
as needed. The rewinder will stop when the printer stops advancing media or when the
printer is out of media.
Summary of Contents for QuickLabel QL-850
Page 1: ...U S E R G U I D E...
