External Unwinder
QL-850 User Guide
112
9.
Guide the media under the unwinder dancer arm [5] and up to the media entry slot. The
inside edge of the media should be aligned squarely with the fixed media guide on the
media entry slot.
If the media is not squarely aligned with the fixed media guide, adjust the position of the
unwinder as needed.
•
Loosen the thumb screws that fasten the unwinder to the bracket. Slide the
unwinder left/right as allowed by the adjustment slots until the media is squarely
aligned with the fixed media guide. Then tighten the thumb screws.
10.
While holding the media near the media entry slot, turn the power switch [5] on the
unwinder to the on position. The unwinder will remove slack and provide back tension
during the loading process.
The media unwind path is illustrated below.
11.
Finish loading media using either the standard method or the manual feed method. Refer
to the related section for details and illustrations.
•
Standard
- Position the adjustable media guide. Guide the media into the printer
and release the media when the printer starts feeding media.
•
Manual
- Position the adjustable media guide. Open the top cover. Lift the roller
handle and then guide the media into the printer until it is positioned under the first
star wheel on the transport unit. Release the roller handle and then close the top
cover. The printer will start feeding media.
Summary of Contents for QuickLabel QL-850
Page 1: ...U S E R G U I D E...
