Ｃｈａｐｔｅｒ ＩＶ Ｌｏｃａｌ Ｏｐｅｒａｔｉｏｎ
87
ARRAY
INP:PROT:CLE
；
Clear the protection status
4.11 Trigger Operation
When the trigger mode is external mode (EXTernal), the operation procedures for trigger
operation are shown as below:
1.
Set the trigger function (Refer to 2.8 for details.);
2.
The trigger terminal (TRIGIN) receives a TTL falling edge signal, and a trigger occurs.
Example 1: Select “List” for the trigger function to trigger a sequence operation. The sequence is
the one mentioned in Example 1 in 4.8.1. The detailed procedures are as below
：
Procedures
Detailed Operation
Step 1
Select “List” in main menu for the trigger function
（
Please refer to
4.14.6 for details.
）
;
Step 2
Send initial command INT or INIT:CONT;
Step 3
Trigger terminal (TRIG IN) receives the TTL falling edge. The load’s
input will change according to the sequence parameters.
The corresponding SCPI commands of the above procedures should be as follows:
TRIG:FUNC LIST
；
Select LIST for the trigger function
INIT
；
Trigger initialization
TRIG
；
A trigger occurs
4.12 Main Menu of the Eload
The operation procedures for the main menu are shown as below:
1.
Press dynamic
key to enter the main menu as the following diagram:
Summary of Contents for 3750A
