Array electronic 3750A, Manual

Page: 73 / 120

Ｃｈａｐｔｅｒ ＩＶ Ｌｏｃａｌ Ｏｐｅｒａｔｉｏｎ
69
ARRAY
POW 1000
；
Set the power level
INP ON
；
Open the load
Example 2: Take 3751A as an example, in CRH mode, set the load to CP mode, the power level
to 1000W, the VON voltage to 15V, the power limit to 1200W, the current rising rate 10A/us and
the current falling rate 6A/us. Turn on the load. The procedures are shown as below:
Step 1: Press key to enter into mode and parameter setting menu;
Step 2: Switch to parameter setting menu via and keys;
Step 3: Move the cursor to the thousand position via the key, then enter number 1 via the
knob or the number keypad; move the cursor to other positions via the key, then enter
number 0 via the knob or the number keypad; then press key to confirm;
Step 4: Switch to VON voltage option via and keys;
Step 5: Move the cursor to the ten position via the key, then enter number 2 via the knob or
the number keypad; move the cursor to the digit position via the key, then enter number 0
via the knob or the number keypad; then press key to confirm;
Step 6: Switch to current limit option via and keys;
Step 7: Move the cursor to the ten position via the key, then enter number 7 via the knob or
the number keypad; move the cursor to the digit position via the key, then enter number 0
via the knob or the number keypad; press key to confirm;
Step 8: Switch to current rising rate option via and keys;
Step 9: Move the cursor to the ten position via the key, then enter number 1 via the knob or
the number keypad; move the cursor to other positions via the key, then enter number 0 via
the knob or the number keypad; press key to confirm;
Step 10: Switch to current falling rate option via and keys;