Ｃｈａｐｔｅｒ ＩＶ Ｌｏｃａｌ Ｏｐｅｒａｔｉｏｎ
64
ARRAY
INP
ON
// Open the load
Notes: In CCH or CCL status, the
or the
will be displayed at the lower right
corner.
4.5.2 CV Mode
Example 1:
Take 3751A as an example, in CCH mode, set the load as CVH mode, the voltage
level is 50V. Turn on the load. The procedures are shown as below:
Step 1:
Press
key to enter into
mode and parameter setting menu;
Step 2:
Press dynamic
key to select
mode;
Step 3:
Enter the voltage level 50 by the number keypad, or via knob with
, and
keys;
Step 4:
Press
key to confirm;
Step 5:
Press
key to turn on the load.
The corresponding SCPI commands of the above procedures should be as follows:
MODE
CVL
; Set the mode
CURR
50
; Set the voltage level
INP
ON
; Turn on the load
Example 2:
In CVH mode, set the voltage level to 60V, the Volt Start to 20V, the voltage limit to
100V, the voltage rising rate 20V/us and the voltage falling rate 24V/us. Turn on the load. The
procedures are shown as below:
Step 1:
Switch to parameter setting menu via
and
keys;
Step 2:
Move the cursor to the ten position via the
key, then enter number 6 via the knob or
the number keypad; move the cursor to the digit position via the
key, then enter number 0
via the knob or the number keypad; then press
key to confirm;
Step 3:
Switch to Volt Start option via
and
keys;
Step 4:
Move the cursor to the ten position via the
key, then enter number 2 via the knob or
Summary of Contents for 3750A
