Aritech 1 3E Series, Installation Manual

Page: 74 / 114

Chapter 3: Configuration and commissioning
68 1X-X3E Series Installation Manual
2. Select a value using the value selection buttons (2 and 4). The Network fault
LED flashes fast to indicate that the Firenet analogue remote node menu is
active.
3. Press Enter.
4. Save your changes.
Advanced configuration options
The following table shows the options (available to an advanced configuration
user) for creating an advanced fire network configuration.
Table 19: Advanced configuration options for the fire network
Display
Description Value
Firenet identifier 0 to 32
0: Stand-alone (no networking)
Default: 0
Firenet group. Allows you to configure
the panel to work in a 32-node network
or in a group of 32 nodes inside a 250-
node network
0000 to 0218
Default: 0000
The number has four digits. Identified
by position, these are: 1234.
Press Up to enter the first two digits of
the number (positions 1 and 2).
Press Down to enter the last two digits
of the number (positions 3 and 4).
Firenet analogue remote node 0000 to 0250
Default: 0000
The number has four digits. Identified
by position, these are: 1234.
Press Up to enter the first two digits of
the number (positions 1 and 2).
Press Down to enter the last two digits
of the number (positions 3 and 4).
Firenet number of nodes [1] 2 to 32
Default: 2
Firenet initial zone number 0001 to 9999
Default: 0001
The number has four digits. Identified
by position, these are: 1234.
Press Up to enter the first two digits of
the number (positions 1 and 2).
Press Down to enter the last two digits
of the number (positions 3 and 4).
Firenet global controls ON/OFF
Default: On
Firenet loop class A/B
Default: B