Aritech 1 3E Series, Installation Manual

Page: 54 / 114

Chapter 3: Configuration and commissioning
48 1X-X3E Series Installation Manual
Display Description
Z1, Z2, and Z3 are configured as extinguishing zones.
No fire detection zones are provided.
No extinguishing zones are provided. Z1, Z2, Z3 are
configured as fire detection zones.
Manual-only mode local
When the control panel is in manual-only mode, the extinguishing process can
only be initiated manually, using the MCP Start device. Automatic extinguishing
events reported from the fire detection zones are disabled for extinguishing
activation.
The panel can be switched to manual-only mode using two methods: by pressing
the Manual Mode button on the control panel interface (local activation), or by a
manual-only mode activation device, such as an external switch (remote input
activation). A remote command can be transmitted from the network.
Use this option to configure which method is used to switch to manual-only
mode. The default configuration is On (the Manual Mode button on the control
panel interface is used for local activation).
For more information see “Connecting an external device for manual-only mode
control” on page 12.
To configure the manual-only mode control:
1. Set the display as shown below, and then press Enter.
The yellow Manual Mode LED flashes fast to indicate that the configuration
menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The available settings for this feature are shown below.
Display Description
Manual-only mode is set locally. Manual-only mode is
activated by the Manual Mode button on the panel.
Manual-only mode is set remotely. Manual-only mode is
activated by the manual-only mode activation device.