Argo All 6X6, Service Manual

Page: 51 / 297

EN-23
Engine System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
12. Attach the overhead hoist to the engine. There are lift hooks provided on each engine.
13. Slowly and gently raise the engine through the hood area with the overhead hoist.
Watch for any wiring they may have been overlooked in disconnecting which may in-
clude some optional accessory kit wiring. Some manoeuvring is required as the engine
does not necessarily come straight up and out. Avoid damage to any other components
as well as the upper body.
14. Place the engine on a clean work bench for service required.
Installing The Briggs 600 Engine
1. Slowly and gently lower the engine through the hood area. Some maneuvering is re-
quired as the engine does not necessarily drop straight in. Avoid damage to any vehicle
components as well as the upper body.
2. Align the holes in the engine block with the press fit studs in the powerpack frame.
Install the flat washers and secure and torque each nut to 209 in-lbs (Dry, Non-Lubri-
cated Condition)
CAUTION
Ensure the studs in the power pack frame are aligned with the correct holes on the
engine block. Not observing this could result in belt misalignment and damage to
drive belt and clutches. Lower the engine with caution or damage could result to the
studs in the power pack frame.
3. Reconnect engine connector plugs in the main wire harness located at the front of the
engine.
4. Reconnect fuel vent from fitting on engine.
5. Reconnect the intake hose from the air filter cannister.
6. Reconnect the throttle cable at the engine cable retainer.
7. Reconnect the ground cable at the engine.
EN INDEX MAIN INDEX