Argo All 6X6, Service Manual

Page: 175 / 297

Wheels, Axles & Chains Argo Service Manual
WA-30
8.
Align the grease zerk on the bearing
flange with the grease hole in the bear -
ing while installing the axle to the ve-
hicle
9. On the inside of the vehicle, slip on the
sprocket assembly orienting the sprock-
ets as illustrated in the Drive Chain
and Sprocket Orientation Charts.
10. Secure the outer greasable flange with four (4) HHCS 7/16-20x1.75 GR5 ZN and Flat
Washers and
torque to 30 FT.LBS (40.6 Nm).
11. Tighten down inner bearing flange hardware and
torque to 30 FT.LBS (40.6 Nm)
12. Align each of the final drive sprockets as shown in the Drive Chain and Sprocket
Orientation Charts
. Ensure retaining clips are snapped into the grooves on the axles
and positioned on each side of the sprocket assemblies to minimize flotation along
the shaft under vehicle application.
IMPORTANT
Front wheel drive sprockets on all vehicle models are free floaters and do not utilize
retaining rings on either side of sprocket.
13. Install the bolt and flat washers to the end of the axle. Apply blue 242 LOCTITE to
the threads of the bolt and torque to 35 FT. LBS.(47.5Nm).
14. Perform the servicing procedure, Outer Axle & Bearing Lubrication.
15. Perform the servicing procedure,
Inner Axle Bearing Lubrication.
16. Perform the servicing procedure,
Installing A Drive Chain.
MAIN INDEX
WA INDEX