Argo All 6X6, Service Manual

Page: 132 / 297

Clutch System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CS-8
Driver Clutch Removal (CVTECH)
1. Remove the engine access cover.
2. Perform the servicing procedure,
Removing the Firewall ,
3. Perform the servicing procedure,
Removing the Drive Belt.
4. Remove the fastener securing the Driver Clutch to the PTO and slide the clutch from
the shaft.
NOTE
The driver clutch must be slid from the PTO with the mounting bolt hardware within the
clutch. The mounting bolt is too long to remove first.
The driver clutch may contact the lower body first before completely being free of the
PTO, however the lower body will flex enough in that area to free the clutch.
5. Remove the clutch to a clean work area for further disassembly.
Disassembling the Driver Clutch (CVTECH)
1. Remove the large hex nut, flat washer and cap.
2. Remove the (3) nylon blocks and weights. Weight grams will vary between models.
3. Remove the (3) fasteners securing spring cover to the sliding flange.
CAUTION
Cap is under spring tension. Slowly unthread each fastener uniformly and a little at
a time until the cap is freed from the sliding flange.
MAIN INDEX
CS INDEX