Argo All 6X6, Service Manual

Page: 140 / 297

Clutch System Argo Service Manual
Ontario Drive & Gear Limited www.argoutv.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CS-16
Installing The Drive Belt (ITDS Clutch System)
CAUTION
This procedure requires as specialized tool to spread the driven clutch sheaves.
1. Remove the bolt securing the driven clutch to the input shaft and insert it through a
piece of flat bar stock (may or may not require some flat washers).
2. Thread the bolt into the driven clutch until the clutch sheaves spread far enough to
easily remove the drive belt.
3. To install the drive belt, position the belt around the driver clutch first.
4. Ease the belt over the edge of the fixed face on the driven clutch and carefully thread
the belt over the top while turning both driver and driven clutch clockwise.
5. Remove the clutch tool and reinstall the mounting bolt.
NOTE
Drive Belt alignment and tension are pre-set and are not adjustable.
Driver Clutch Removal (ITDS)
1. Remove the engine access cover.
2. Perform the servicing procedure,
Removing the Firewall
,
MAIN INDEX
CS INDEX