Argantix XDS 100-100, User And Programming Manual

Page: 92 / 116

User and Programming Manual
92 XDS Series
[SOURce:]MODE
This command is used to query the power supply's operating mode. The power supply can operate
in either Constant Voltage or Constant Current mode. A numeric value is returned for a MODE?
Query and is encoded as shown in the table below:
Value Mode
0 Undefined.
1 Constant Voltage (CV)
2 Constant Current (CC)
3 Cross over CV and CC mode
Table 11-1: Mode query result decoding
Command Syntax [SOURce:]MODE?
Parameters None
Query Syntax
MODE?
Returned Parameters <NR1>
Related Commands none
[SOURce:]VOLTage[:LEVel]
This command programs the DC output voltage level of the power supply.
The voltage may be set between the low limit and high limit as programmed using the VOLT:HIGH
and VOLT:LOW commands. However, the high limit cannot be higher than the model's capability
(configuration limit) which can be queried with the LIM:VOLT? command. The low limit cannot be
less than zero. The *RST state for high and low voltage is zero for low, and maximum configuration
limit voltage for high. (model specific).
Command Syntax [SOURce:]VOLTage[:LEVel] <NRf>
Parameters value between VOLT:HIGH and VOLT:LOW settings.
Unit V (rms voltage)
*RST Value 0 volt
Examples VOLT 250 VOLT:LEV 25
Query Syntax [SOURce:]VOLTage[:LEVel]?
Returned Parameters <NR2>
Related Commands VOLT:HIGH VOLT:LOW