TITAN-SVX Software Manual
page 24
Rev 4.01
Example 1:
Command from Master to TITAN-SVX
@AQ:SREQCMD=281
Reply from TITAN-SVX to Master
#00:NETID=1;PROT=0[CR][LF]
Above example shows a query command for the network ID and Protocol
setting. No matter what the Communication Mode is, this Special Request
Command 281 can be used to get the Network ID and the Communication
Mode of the TITAN unit.
Example 2:
Command from Master to TITAN-SVX
@AQ:SREQCMD=400
No reply from TITAN-SVX to Master will be sent.
Above example shows how to reset the communication mode to 0
regardless of what the current communication mode TITAN is configured
with. If the new communication mode is to be used from now on after
issuing this command, make sure to store to the flash using command 285
so that the new communication mode will be stored in the flash and be
used even after the power cycle.
Example 3:
Command from Master to TITAN-SVX
@AQ:SREQCMD=285
No reply from TITAN-SVX to Master will be sent.
Store to flash command will store all the settings including the Network ID
and the Communication Mode to the flash memory.
