Aquaprobe
®
AP-7000 Instruction Manual
10401-00894 Rev M
Finally, slide the side brush from the wiper.
Re-assembly is simply the reverse of this process.
Tips:
•
Ensure the brushes are re-fitted the right way round. Refer to the photographs above
if in doubt.
•
Before sliding the wiper back onto the central shaft, rub a small amount of silicone
grease onto the shaft.
•
When sliding the wiper back onto the shaft, ensure the hole in the top brush carrier
is in alignment with the central hole in the wiper.
•
Ensure that the torque arm (see below) is aligned with the corresponding receiving
hole in the end of the wiper.
Finally, ensure the spring clip is correctly and securely fitted.
© 2017 Aquaread
®
Ltd.
www.aquaread.com
Page 37 of 143
