AP006 P36
C
C 16
C 17
C 18
GALVANIZED STEEL RACK (FITTING DATA)
Fitting:
The threaded supports must be welded to the gate (C16). It is advisable to
weld the entire circumference.
ATTENTION
•
Do not weld the rack piece directly to the gate (this would impede any
adjustments).
•
NEVER attach the spot-welder earth to the geared-motor.
Joining and aligning of the pieces:
In the galvanized steel rack the pieces must be joined by using the counter
reference template (C17) (see fitting instructions in the next paragraph).
ATTENTION
•
Never weld adjacent sections to one another or close the free space
between them (this would impede any adjustment).
•
PROTECT ALL THE WELDS WITH ANTI-RUST TREATMENT USING
ZINC SPRAY.
FITTING OF THE RACK (BOTH TYPES)
ATTENTION
The figures of the following instructions refer to the steel rack, but the
basis technics is the same of the plastic rack.
Open the gate completely and release the geared-motor pinion with the
manual release key (see page 15); fit on the first rack section (C 18
➀
), the
spacers (C 18
➁
) with their screws (C 18
➂
) and washers (C 18
④
), making
sure that the screws pass through the centre of the slot.
