AP006 P6
✔
Geared-motor on sliding gates and doors up to 500 kg (ONDA 500) or 800kg (ONDA 800) for residential use;
✔
Irreversible worm reduction gear (ratio 1/30) with permanent grease lubrication.
✔
Adjustable torque limiter clutch on fast shaft.
✔
Pinions: Z16 (standard), Z20*, Z16 for chain*.
✔
Electromechanical limit switch (IP55 protection)
✔
Secured to the ground with foundation plate or screw anchors.
✔
Diametral pitch 4 rack: either the plastic or the galvanized steel one can be used; the end travel plates are the same for both.
✔
Triangular key for manual release.
✔
Suitable for T2B control units.
✔
Control unit can be fitted inside the geared-motor .
✔
Ready for internal fitting of the Aprimatic receiver.
*
The pinions Z20 and Z16/Chain can be ordered separately.
PRELIMINARY CHECKS
GENERAL CHARACTERISTICS
AP006 P7
GEARED-MOTOR DIMENSIONS
B
238
309
188
134
20
34
AP006001AP006001AP006001AP006001AP006001
WARNING
•
The gate structure must comply with the current safety regulations.
•
The main feature that must be assessed is SMOOTH SLIDING: a good gate MUST be easy to move by hand (with more or less effort, depending
on the weight), to allow opening in the event of manual release.
A list is given below of the main factors that affect the sliding of the gate and its constant performance over time.
FABRICACION DE LA PUERTA
The gate must be stiff, straight and in good condition: eliminate, where present, any type of automatic lock.
CONTROLLI PRELIMINARI
GATE CONSTRUCTION
VORKONTROLLEN
CONTROLES PRELIMINARES
B
