AP006 P34
C
C 13
C 14
PLASTIC RACK (FITTING DATA)
The rack is made by thermoplastic; it has a steel core and can move gates up
to 400kg. It is simple to install without the need of welding.
Fitting:
The plastic rack is normally fixed to the gate with screws. Four self-tapping
screws (for each piece) are provided in the kit
which are fitted as in C13. With these screws, it is advisable to drill the hole
depending on the thickness and on the material of the supporting base,
according to the following table:
Thickness
Material
mm
Steel/Brass
Aluminium
1,5 ÷ 1,9
Ø 5,2
Ø 5,1
1,9 ÷ 2,7
Ø 5,3
Ø 5,2
2,7 ÷ 3,4
Ø 5,8
Ø 5,3
3,4 ÷ 4,8
Ø 6
Ø 5,4
4,8 ÷ 5
Ø 6
Ø 5,6
Note: In case of wooden doors, check the good condition of the wood
in the fixing points and use proper screws.
Joining and aligning of the pieces:
In the plastic rack, the joining of two sections of rack is facilitated by matching
notches on the heads of the sections (C14) which helps the aligning.
Clean the possible trimmings on the angles of the matching notches.
ATTENTION
To maintain correct alignment and pitch it is advisable to use a reference
template (C15
➀
); if necessary, make adjustments on the matching
notches.
C 15
