AP006 P30
C
C 8
C 9
C 10
POSITIONING ON THE SLIDING PLATE
ATTENTION
Do not handle the ONDA 500 / ONDA 800 by grasping it by the plastic
cover; the stop screw can cut the cover.
Proceed as follows:
Unscrew the stop screw (C8
➀
) and remove the cover pulling upwards (C8
➁
).
ATTENTION
The cover slides vertically on two guides (C8
③
). Refer to them when
mounting the cover (see D8 page 50).
Fit the ONDA 500 / ONDA 800 in the support plate and make sure that the
geared-motor is perfectly parallel to the gate (C9
④
) and at the CORRECT
DISTANCE from the rack support surface (58-62 mm).
Secure the geared-motor to the plate with the securing screws (C10
➄
) by
unscrewing them and placing them on the plate.
ATTENTION
Push the geared-motor against the plate on the opposite side of where
the securing screws (C10) are to have a correct securing.
TIGHTEN BUT NOT EXCESSIVELY THE SCREWS UNSCREWING THEM.
ATTENTION
If you have difficulties with the screw securing key, the ONDA 800 has
two additional threaded holes (C10
⑥
) on the opposite side to where the
screws are moved (MOVE BOTH OF THEM ALWAYS ON THE SAME
SIDE).
Close the plastic cover temporarily to protect the inner parts while the rack is
being fitted (see D8 page 50).
