AP006 P40
D
ELECTRIC CONNECTIONS
ATTENTION
Before making the connections, it is essential to read and follow the instructions for the electronic control unit used.
The electric connections with the accessories (photocells, flashing lights, etc.) are done as described in the control unit manual and in the figure D1; it is advisable
to use adequate cables (see D1 for the minimum sections to use).
ATTENTION
When making the connections, make sure that the control unit is not connected to the mains. Furthermore, the unit should be protected by an
automatic differential switch (D1).
ATTENTION
The electric connections should be made, observing the existing safety regulations, by qualified personnel.
NOTE: On ONDA 500 E / ONDA 800 E, ref. “8” is on the motor gear unit
1
Radio-receiver
2
Flashing light
3
Photocell receiver
4
Photocell transmitter
5
Internal pushbutton
6
Pushbutton panel, card reader or key control
7
Geared-motor
8
Electronic control unit
9
Safety edge
D 1
