2 Safety Instructions
C76IB003EN-E
11
•
The installation procedure shall only be carried out by authorized personnel
who are familiar with the installation instructions.
•
Do not use any accessories or wearing parts other than those supplied or
approved by Anton Paar GmbH.
•
Make sure all operators are trained to use the instrument safely and correctly
before starting any applicable operations.
•
In case of damage or malfunction, do not continue operating DMA 4100/
4500/5000 M. Do not operate the instrument under conditions which could
result in damage to goods and/or injuries and loss of life.
•
If liquid was spilled over the instrument, disconnect the instrument from the
mains. Clean and dry the housing of the instrument. If you have a suspicion
that liquid got into the instrument, have the instrument cleaned and checked
for electrical safety by a service technician.
•
Ensure that spilled liquids cannot get into plug connections or venting slots of
electrical equipment.
Moving the instrument
•
Make sure that all hoses and the measuring cell are empty before you move
or lift DMA 4100/4500/5000 M.
•
To move or lift DMA 4100/4500/5000 M, place one hand at the back and grip
the ledge at the top. Place the other hand at the front, under the display.
There is a hollow for your fingers.
•
When carrying the system, keep it close to your body.
Handling of chemicals
•
Observe all safety regulations regarding the handling of the samples,
cleaning, rinsing and waste liquids (e.g. use of safety glasses, gloves,
respiratory protection, exhaustion, etc.).
•
Check the chemical resistance of all materials (see Appendix A.2) which
come into contact with the sample or cleaning liquid before starting the
measurement.
•
Make sure that different liquids (samples and cleaning liquids) or gases that
come into contact with each other are chemically compatible. They should
not react exothermally or produce any solid particles that might stick to the
inner wall of the measuring cell.
•
Prior to starting a measurement or cleaning procedure, make sure that all
parts that come into contact with fluids, especially the measuring cell, the
injection adapters, hoses and waste container, are properly connected and in
good condition.
