Antec DECADE Elite, Service Manual

Page: 58 / 72

58 175.0020 - DECADE Elite service manual - rev 03
6. Installation of internal cell cable
•
Remove the plastic cover strip from the cell connector opening
(sensor 2) in the cell cabinet (top-left side) using a tweezer or
other pointed metal object. Bend the metal retaining clips outwards
to be able to shove them from the plastic fixing pins (see photo on
the previous page).
•
Apply the corresponding vinyl
label ‘Sensor 2’ (upgrade SCC->
DCC) or ‘Sensor 3’ (upgrade DCC →
TCC) to the new internal cell
cable before installation. The label should be applied on the thin
unshielded black lead close to the male connector on the cable.
•
Fix the cell connector of the internal cell cable (female connector
with threaded bushing) in the corresponding connector opening in
the cell cabinet with the two
hex screws using the 3/16” socket
wrench.
•
Fix the internal cell cabinet in the housing using the four M3x8mm
screws.
•
Insert the four rubber liners back into the inlet/outlet (tubing) open-
ings of the oven compartment.
Figure 16 Left: labelling internal cell cable Right: Fixing the cell connector
in the corresponding D-sub connector opening in the cell cabinet panel.