Chapter 6
Sensor board installation
59
7. Reconnecting wiring & mounting rear panel
Follow the steps below to reassemble the instrument:
•
Fix the two (or three) connectors of the internal cell cables into the
corresponding sensor board connectors using hex screws with two
plastic washers as depicted in the photo below.
•
Insert the two (or three) internal cell cables into the white cable
clamp on the top side of the PCB frame.
•
Reconnect all wiring (power, heater, fans, door sensor, temp sen-
sor, keyboard and LCD display connectors) on the control board.
•
Insert the cables of the door sensor, fans and temperature sensor
into the white cable clamp on the bottom side of the PCB frame.
•
Place the rear panel back into the main detector enclosure and fix
the panel using the two 3Mx12mm screws (top side) and the two
3Mx8mm (bottom side). Use one plastic washer per screw.
Figure 17 Left: Fixing the internal cell cables on the sensor board connect-
ors. Right: Reconnecting all internal wiring on the control board.
Summary of Contents for DECADE Elite
