Anritsu MS8608A, Operation Manual, Page: 69 / 338

Section 4 Basic Operation Procedure
4-3
The basic operation procedure of this equipment is
explained here. The operations are listed on the right.
Also, the explanation will advance assuming that a
500 MHz signal is applied to the input connector.
Please refer to this manual while operating this
equipment.
( : Panel key, : Soft key)
<Actual operations>
(I) Signal display
1) Turn the power on,
2) Move to spectrum analyzer mode,
3) Execute automatic calibration,
4) Set the signal to the center of the screen,
and
5) Enlarge and display the signal.
(II) Marker operation
Check of the zone marker function.
The “marker
→
CF” function check.
(III) “Measure” function check
(IV) Screen hard copy
Signal Display
Turn the power on
Press the standby button on the rear panel, then press the power switch on the front
panel. In this case, continue pressing the power switch for one second or more.
The power is turned on/off only when the power
switch is pressed for one second or more. This
prevents the power from being turned on/off easily
by mistake.