Anritsu MS8608A, Operation Manual, Page: 163 / 338

6-51
Section 6 Performance Tests
(4) Procedure
(a) sweep time
≥
100 ms
Step Procedure
1
Press the MS8608A/MS8609A Preset key.
2
Operate All Cal.
3 Connect the Sweep Status (Z) output of MS8608A/MS8609A to Input A of MF1601A.
4
Set the MS2683A MS8608A/MS8609A as shown below:
Center Frequency .................................. 300 MHz
Span ........................................................... 2 MHz
Ref Level ................................................... 0 dBm
RBW .......................................................... 3 MHz
VBW ............................................................ Auto
Detection .................................................. Sample
Sweep Time .............................................. 100 ms
5
Set the MF1601A as shown below:
Input .................................................................. A
Function ............................................. Pulse width
Couple ............................................................ DC
Slope .............................................................. Rise
6
Press the MS8608A/MS8609A Single key.
7 Reset the MF1601A.
8
Press the MS8608A/MS8609A Single key, and measure the pulse width of sweep status
output.
9 Repeats steps 6 to 8 at each sweep time of below table.
Setting the MS8608A/MS8609A
Sweep time
Measured result
100 ms
500 ms
10 s
100 s