Anritsu MS8608A, Operation Manual, Page: 255 / 338

SECTION 5 INITIAL SETTINGS
5-7
Device Initialization using the INI/IP Command
■
Syntax
INI
IP
■
Example (program message)
For RS-232C
WRITE #1,"INI"
For GPIB
SPA%=1
CALL
Send(0,SPA%,"INI",NLend)
Initializes the device (MS8608A/MS8069A) at address 1 at level 3.
■
Explanation
The
INI
and
IP
commands are the MS8608A/MS8609A spectrum analyzer function device-dependent messages
that initialize a device at level 3.
For details of the items that are initialized by the INI and IP commands, and the settings after initialization, see
Appendix C.
Device Status at Power-on
When the power is turned on:
(1) The device is set to the status it was in at power-off.
(2) The Input Buffer and Output Queue are cleared.
(3) The Parser, Execution Controller, and Response Formatter are initialized.
(4) The device is put into OCIS (Operation Complete Command Idle State).
(5) The device is put into OQIS (Operation Complete Query Idle State).
(6) The Standard Event Status and Standard Event Status Enable Registers are cleared. Events can be recorded
after the registers have been cleared.