ANISOPRINT Composer, User Manual, Page: 27 / 57

Composer User Manual
Press the RESUME button to continue the print from the stopping point.
Press the CONTROL button in printing mode to tune the printing process. The screen when the CONTROL button
is pressed in the printing mode is shown below.
Here, the following settings are available:
1, 3 and 4 buttons are the same as for paused print
2 – Correct Z. If the first layer of the print is too thick or thin you can move the buildplate up or down by 0.01/0.1/1
mm to achieve the optimum thickness of the first layer. Notice, that this setting does not influence the Z axis
calibration.
27 / 57