ANISOPRINT Composer, User Manual, Page: 24 / 57

Composer User Manual
1 – Fiber perimeters
2 – Cellular fiber infill
3 – Outer plastic perimeters
4 – Plastic top cover
5 – Plastic shell
After several plastic layers, the machine will start the first fiber perimeter and fiber cellular infill. Due to the
process features, it may look a bit wobbly, but the layup visual quality will normalize later on. If the fiber
goes off trajectory or doesn’t glue to the previous layer, go through the Z OFFSET CALIBRATION
procedure.
During the next plastic-composite cycles, fiber perimeters will be surrounded by plastic ones. Make sure
the plastic and fiber perimeters do not intersect and fiber perimeters are laid without displacements.
Inspect the printed part paying special attention to side walls quality. Check the surface smoothness
visually and compare it to the photo above. In case of poor side walls quality, go through the Z OFFSET
CALIBRATION procedure.
Congratulations on your first print!
7.9. In-situ tuning of printing settings
Some basic operations with the printer are still available during the printing.
After you start the print, the PRINTING screen appears. Here you can pause your print by pressing the PAUSE
button, or adjust the printing process by pressing the CONTROL button.
24 / 57