Angelo Po 0G0FR3E, Use And Installation Manual

Page: 28 / 85

- 10 -
C13143
000.
fm
IT
GB
DE
FR
ES
English
To carry out this operation,
proceed as follows.
1 - Switch the appliance off
and leave it to cool (see
page 7
).
2 - Turn off the circuit-
breaker to disconnect it
from the electrical
mains.
3 - Drain and filter the oil
(see page 8).
4 - Remove and clean the
baskets and the basket
support structure
(A)
.
5 - Turn the heating elements into the vertical posi-
tion.
6 - Apply a food-grade detergent to the inside of the
well.
7 - Rinse the well with drinking water and
drain.
8 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
9 - Rinse, empty and dry the well.
10-After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
The appliance has been tested before being put into
service. The information provided below is intended
to assist in the identification and correction of any
anomalies and malfunctions which might occur dur-
ing use. The user can solve some of these prob- lems himself, but for others specific technical
knowledge or skill is required, and so they must only
be carried out by qualified staff with recognised ex-
perience acquired in the specific sector of operation.
CLEANING WELL, BASKETS AND BASKET SUPPORT STRUCTURE
FAULT 6
TROUBLESHOOTING
Fault Cause Remedy
The heating elements do not
come on.
Electrical connection not made
correctly.
Check the connection of the
electrical wires.
Safety thermostat tripped.
Carry out the appliance reset
(see page 14).
Switch faulty. Replace the switch.
IDM-39604002100.tif
A
C13143000.fm Page 10 Thursday, June 12, 2008 2:23 PM