ANDREWS COMBIfl o
38
GB
4.19.1 OUTSIDE SENSOR B9 (OPTIONAL)
This outside sensor is a NTC 1K resistance type. It is a passive sensor for
monitoring of outside air temperature and to a small extent - solar radiation.
It should be mounted so that it is not exposed directly to the sun (especially in
the morning). In case of doubt it should be located on a wall facing North to
North-West. The infl uence of the wind and the temperature of the wall must also be
considered.
When fi tting an outside sensor to the appliance, please remember to remove and discard the
resistor fi tted between the electrical connection points.
4.19.2 ROOM UNITS QAA55 (OPTIONAL)
QAA55
(P/N 5138511)
4.19.3 POSITIONING OF ROOM UNITS
Install room units in the main occupancy rooms. The place of installation should be chosen so that the sen-
sor can capture the room temperature as accurately as possible without getting adversely aff ected by direct
solar radiation or other heat or refrigeration sources (about 1.5 metres above the fl oor)
See illustration on the following page for guidance on sensor positioning
4.19 OUTSIDE SENSOR & WIRED ROOM UNITS
Summary of Contents for COMBIflo 100/300
