Amylior LOGOSILVER OUTCHAIR L, Owner'S Manual

Page: 51 / 76

P·51
• Fully charge the chair at night, checking that the charger indicates that the battery is
fully charged (switches to charge maintenance mode).
• Repeat steps 2 and 3 the first 20 times (cycles) to complete the «break-in» procedure.
7.10.4. Charging procedure
The battery is charged via a socket located on the joystick module. When the charger is
plugged in, the module recognizes it and stops the chair from moving. The following procedure
is applicable for the recommended charger brand (See separate charger instructions if using
an alternative charger).
• Make sure the chair is off using the on / off joystick button.
• Make sure the circuit breaker fuse is armed so as not to prevent the batteries
recharging.
• Make sure the charger is turned off before plugging it into the chair.
• Plug the charger into the jack on the joystick module.
• Connect the charger to the 220 V mains.
• Please refer to the manual supplied with your charger for detailed instructions.
Here are some tips for taking care of your batteries:
• Avoid ultra-deep discharges (total discharges reduce the life cycle).
• Do not leave batteries on a low charge for a long period (for example, after a day of
use, completely recharge the batteries during the night).
NOTES
The battery capacity is limited when it is new, this is perfectly
normal, and this will improve during the breaking-in process.