P·35
7.8.4. Joystick cable
If, for any reason the joystick cable is disconnected, be careful not to force it back in again.
The plug is polarized and can only be inserted in one direction.
7.8.5. The control programme
The control programme affects the speed, acceleration, deceleration, and braking of the
chair. The drive mode settings are pre-programmed at the factory. If your distributor changes
these settings, please take note.
7.8.6. Precautions for use
The R-net cannot take into account circumstances that place the chair or controller beyond
the specified operating conditions, and it is therefore important that the user takes the
following precautions:
Do not drive the chair:
• Beyond the restrictions specified in the chair manual, for example regarding the
maximum inclination, the maximum height of the sidewalk, etc.
• On surfaces where loss of adhesion could be dangerous, for example on a wet grass
slope.
• It is known that the controller or another essential component needs to be repaired.
WARNING!
Do not insert the plug in the wrong direction, as this may cause
irreparable damage to the electronic system. Also, be sure to place
the cable so that it cannot get caught in the seat frame or the base of
the wheelchair.
WARNING!
Do not try to reprogram your chair yourself. This task must only be
carried out by the wheelchair manufacturer, an authorized
representative of the manufacturer or a qualified technician.
WARNING!
Logo-Silver assumes no liability for any type of damage resulting from
the unforeseen breakdown of the wheelchair or bad programming
of the control system, improper use of the wheelchair or control
system, or if one of the criteria detailed in this document has not been
respected.
Summary of Contents for LOGOSILVER OUTCHAIR L
Page 1: ...OUTCHAIR S AND L MODELS THE ALL TERRAIN CHAIR You can find this notice on www logo silver fr...
Page 73: ...P 73...
Page 74: ...P 74...
Page 75: ...P 75...
