Amylior LOGOSILVER OUTCHAIR L, Owner'S Manual

Page: 25 / 76

P·25
• Be careful as the incline of the seat must be as parallel to the ground as possible and
the incline of the backrest must be as perpendicular to the ground as possible. This will
avoid any risk of tipping backwards when crossing the front wheels over the obstacle.
• Advance at low speed to transition to the front wheels (between 1 and 2 km / h).
• When the obstacle is underneath the centre of the chair, use this momentum to
accelerate and pass the rear wheels over it (3km / h maximum). It is necessary to
accelerate, as this gives the chair the power necessary to transition to the back wheels.
• When dismounting an obstacle, position yourself as perpendicularly as possible to it
and descend slowly (1 to 2 km / h) forward.
• When you are in hilly or uneven areas with obstacles of more than 4 cm in height
(dips, bumps, stones, branches ...), use the driving profile «crossing» and do not exceed
3 km / h when passing over these obstacles. If you have the steering lock option, it is
advisable to use it.
• When you need to climb over slopes, ensure that they do not have an incline greater
than those specified by the technical features (see chapter 3. Technical Features). Make
sure you are in a configuration that allows you to cross over these slopes (sufficient
grip, no obstacles greater than 4 cm on the slope ...). Do not attempt to turn around
on a slope greater than that of the maximum lateral slope as you could tip over
sideways. If you cannot climb a slope, try as much as possible to reverse perpendicular
to it. Limit acceleration on slopes in order to keep momentum, if you do not have
enough momentum, the off-road profile will allow you to gain more. If you have the
steering lock option, it is advisable you use it to keep the wheels straight.
7.3. «INDOOR» DRIVING PROFILE WITH CASTERS
OPTION
This procedure should only be used if you need to release the casters for indoor use in
order to have increased manoeuvrability (increased turning radius).
The procedure for the correct use of this option is as follows:
1. Position the front wheels straight while moving forward slightly.
2. If you have the steering lock it is advisable to use it to lock the front wheels straight.
3. When at a standstill, select the casters option with the MODE button while moving the
joystick right or left.
4. Push the joystick forward until the casters have released completely.
5. When the casters are out, the front wheels are raised a few centimetres, they can no longer
rotate, and the forward gear driving speed is limited to 3 km / h. If this is not the case, refer
to section 10.5. Caster (optional) Malfunction.
6. To use the casters, select the “indoor” driving profile, which is more suitable due to its
increased rotation speed.
7. To return to 4-wheel drive, stop and select the wheel option with the MODE button by
moving the joystick to the right or left.
8. Fully retract the casters by pulling the joystick towards you.