Amylior LOGOSILVER OUTCHAIR L, Owner'S Manual

Page: 22 / 76

P·22
Fig. 4
Fig. 5
6.2. INITIAL CHARGING AND SETUP
Before setup, recharge the batteries with the help of the charger provided by connecting
the power cord to the front of the joystick for a minimum of 5 hours, the charger indicators
must be green (they can also be orange: completely dead or moderately low). See charging
details in chapter 7.10 Batteries and recharging.
To charge the chair, make sure that the circuit breaker does not switch off the general power
supply of the chair (if your wheelchair has one).
Circuit breaker on Circuit breaker off
VII. USE
The OUTCHAIR is equipped with a joystick controller to guide it.
The PROFILE button is used to navigate between the different driving profiles.
It includes 3 or 4 driving profiles (depending on the options chosen):
• «Outdoor» profile: 4-wheel drive wheelchair propulsion, adapted to most terrain with
the ability to go at maximum speed.
• «Flexible-Outdoor» profile: 4-wheel drive wheelchair propulsion, adapted to road-type
terrain, steep paths, city for more maneuverability when turning.
• «Crossing» profile: 4-wheel drive propulsion, adapted to obstacle clearance (a step, a
sidewalk, etc.) with increased instant torque and a maximum speed of 5 km / h. It is
advisable to use the steering lock in crossing mode if you have the option.
• «Indoor» profile (optional): 2WD propulsion, adapted to use with indoor casters.
This mode increases the gyration speed allowing for standard control of an indoor
wheelchair. It is advisable to use the steering lock in indoor mode if you have the
option.
The joystick is used to control the special features via the MODE button (seat tilt, retraction
of the casters, leg rests, backrest tilt, environmental control...).