Installation Procedures: 12" and 15" Panels
34
12” and 15” Modero Touch Panels
5.
Remove the I/O connector plate by using a grounded Phillips-head screwdriver to turn the two screws and
slide the I/O connector plate away from the back box housing.
6.
Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 33). These screws secure
the back box to the internal panel casing.
7.
Lift the back box housing to separate it from the internal panel casing.
Installing the MP-TP12/15 Back Box
1.
Unscrew the four pan-head Housing screws (#8-32) from the MP-TP12/15 rear plastic cover.
2.
Gently place the MP-TP12/15 back box over the internal panel casing (with the cable routing hole on the
right-side of the panel).
3.
Re-install and secure the four pan-head Housing Screws into their pre-drilled holes along the edges of the
MB-TP12/15 back box (FIG. 34) and secure them using a grounded Phillips-head screwdriver.
4.
Place the I/O connector plate back over the connector opening and align the connector locations.
5.
Resecure the I/O connector plate (using a grounded Phillips-head screwdriver) and resecure the nut onto
the Stereo Output jack.
FIG. 33
Location of the attachment screws on the NXD back box
Unscrew these four
DO NOT
these
DO NOT REMOVE
REMOVE
panel
securing
screws
these panel
securing screws
Housing Screws to
remove the back box
DO NOT REMOVE THE FOUR PANEL SECURING SCREWS
. These screws secure
the LCD to the metallic casing underneath.
