Touch Panel Accessories
18
12” and 15” Modero Touch Panels
Installing CAT5 Suppression Ferrites
Before connecting the RJ-45 cables to the Modero Touch Panel, install the necessary number of CAT5
Suppression Ferrites (FIG. 15) to their appropriate locations. These ferrites come as part of the Installation
Kits mentioned in the previous Specification table (page 15).
No tools are required for this installation.
1.
The CAT5 Suppression Ferrite is housed within a plastic enclosure (shown in FIG. 15) with a latch
release on one side. Pull to release the latch and open the enclosure.
2.
Grasp the end of the Modero Table Top cable being connected to the panel. This end of the cable is longer
than the opposing end which connects to the breakout box (6 inches vs 3 inches). Refer to FIG. 16 for
more detailed information.
3.
Insert the panel-end of the Black RJ-45 Audio/Video cable into the groove along the inside of the
enclosure.
4.
Snap the enclosure shut with the cable inside and you’re done.
5.
Repeat this process again only when installing an additional CAT5 Suppression Ferrite (model specific).
Each bundle of 4 twisted pairs includes a colored tape indicator for identification.
FIG. 15
Installing the CAT5 Suppression Ferrites
Release the latch to
open the plastic
enclosure.
Insert the CAT5
cable and close
the enclosure.
Push down on the
enclosure until it
snaps closed.
All video-capable panels require the installation of an appropriate number of CAT5
Suppression Ferrites when they use an RJ-45 cable to feed an A/V signal from the
breakout box.
The CAT5 Suppression Ferrites MUST be installed onto the cable connected to the
Modero’s Audio/Video RJ-45 connector (just behind the connector).
FIG. 16
Ferrite connector location on Audio/Video RJ-45 cable
1
3
2
6 inches
To Touch
Connector
3
- used for Power
Connector
1
- used for Audio/Video (Black)
Connector
2
- used for Ethernet (White)
Panel
Ferrite
Fe
rrit
e
