Upgrading Modero Firmware
40
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
6.
From within Studio, select
Tools
>
Firmware Transfers > Send to NetLinx Device
from the Main menu to open
the Send to NetLinx Device dialog (
B
in FIG. 37).
Verify the panel’s System and Device number
values match those values listed within the System folder in the
OnLine Tree
tab of the Workspace window (
A
in FIG. 37).
7.
Select the panel’s Kit file from the
Files
section.
8.
Enter the
Device
value associated with the panel and the
System
number associated with the Master listed in the
OnLine Tree
tab of the
Workspace
window.
The
Port
field is disabled.
9.
Click the
Reboot Device
checkbox.
This causes the touch panel to reboot after the firmware update process is complete.
The reboot of the panel can take up 30 seconds after the firmware process has finished.
10.
Click
Send
to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog (
B
in
FIG. 37).
11.
As the panel is rebooting, temporarily unplug the USB connector on the panel until the panel has completely
restarted.
12.
Once the first panel page has been displayed, reconnect the USB connector to the panel.
13.
Right-click the associated System number and select
Refresh System
.
This causes a refresh of all project systems, establishes a new connection to the Master, and populates the System
list with devices on your particular system.
14.
Confirm that the panel has been properly updated to the correct firmware version.
FIG. 37
Using USB for a Virtual Master transfer
B
A
Summary of Contents for Modero NXD-500i
