Panel Calibration
19
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
Panel Calibration
Overview
This section outlines the steps for calibrating the touch panel.
Calibrating the panel before its initial use and after
completing a firmware download is highly recommended.
Modero panels are set up in the factory with specific demo touch panel pages. The first splash screen that appears
indicates the panel is receiving power, beginning to load firmware, and preparing to display the default touch panel
pages. When the panel is ready, the AMX Splash Screen is replaced by the Initial Panel Page.
Calibrating the Modero Panel
1.
Press and hold the grey
Front Bezel
button (FIG. 15) for
8 seconds
to pass over the
Setup
page and access the
Calibrate setup
page (FIG. 16).
2.
Press the crosshairs (on the
Calibration
page) to set the calibration points on the LCD (FIG. 16).
3.
After the "
Calibration Successful.
" message appears, press anywhere on the screen to continue and return to the
Setup
page.
If the calibration was improperly set and you cannot return to the Calibrate page through the panel’s firmware,
this firmware page may be accessed via G4 WebControl, where you can navigate to the Protected Setup page and press
the
Calibrate
button through a VNC window.
This action causes the panel to go to the
Calibrate
page seen above, where the actual touch panel may be physically
calibrated again using the above procedures.
FIG. 15
Location of Front Setup Access button
FIG. 16
Touch Panel Calibrate Screens
Front Bezel button
4 second press/hold:
Opens the Setup page
6 second press/hold:
Opens the Calibrate page
Single press puts
the panel to sleep
The request to touch the crosshairs
is the first on-screen message
Calibration successful
is the second
on-screen message that appears
On-screen crosshairs used for
calibration of the touch device
after the calibration process is
completed
Summary of Contents for Modero NXD-500i
