Configuring Communication
27
NXD-500i 5" Modero Wall/Flush Mount Touch Panel with Intercom
4.
Right-click on the System entry (
A
in FIG. 25) and select
Refresh System
. This causes a refresh of all project
systems, establishes a new connection to the Virtual Master, and populates the System list with devices on your
particular system.
Configuring a Wired Ethernet Connection
It is necessary to tell the panel as to which Master it should be communicating. This "pointing to a Master" is done via
the
System Settings
page, where the IP Address, System Number and Username/Password information assigned to the
target Master is configured.
Until those parameters are configured, your Connection Status icon will remain red, indicating that it has no current
connection to a Master.
Step 1: Configure the Panel’s Wired IP Settings
This panel has only one method of communicating to a target Master over the Internet:
Wired
(direct Ethernet
connection, as wireless communication is not available on the NXD-500i).
The connection parameters may only be configured through the System Connection page. This type of communication
can be established either via either a Dynamic IP Address (
DHCP
) or via a pre-reserved Static IP Address (
typically
provided by your System Administrator
).
IP Settings section - Configuring a DHCP Address over Ethernet
1.
Select
Protected Setup > System Settings
(located on the lower-left) to open the
System Settings
page.
2.
Locate the
IP Settings
section of this page.
3.
Toggle the
DHCP/Static
field (
from the IP Settings section
) until the choice cycles to
DHCP
.
FIG. 25
Repopulating the System List
Even though the Host, Gateway, Primary DNS, Secondary DNS, and Domain fields
appear on the two separate System Connection and Secondary Connection pages;
the information populating these fields is identical.
If the information within one of these fields is altered, the change is reflected on both
pages within the altered field.
Example
: if the domain is altered on the Secondary Connection page, the value is
then also changed within the Domain field of the System Connection page.
Summary of Contents for Modero NXD-500i
