![background image](http://html1.mh-extra.com/html/amx/axm-mlc/axm-mlc_instruction-manual_2939200022.webp)
14
Installing the Mini-Touch Panel
Black/White LCD Mini-Touch Panels
Touch overlay
ribbon cable
connector
AXlink
connector
RS-232
4-pin header
Backlight
connector
Guidelines
Mini-touch panels require 12 VDC power to operate properly. The AXCESS Control
System supplies power via the AXlink cable. The maximum wiring distance between
the control system and mini-touch panel is determined by power consumption,
supplied voltage, and the wire gauge used for the cable. Figure 15 lists wire sizes
and the maximum lengths allowable between the mini-touch panel and control
system. The maximum wiring lengths for using AXlink power are based on a
minimum of 13.5 volts available at the control system’s power supply.
Wiring guidelines
Wire size
Maximum wiring
length
18 AWG
234 feet
20 AWG
148 feet
22 AWG
92 feet
24 AWG
58 feet
If you install the mini-touch panel farther away from the control system than
recommended in Figure 15, connect a 12 VDC power supply to the TiltScreen,
UniMount, and rack-mount mini-touch panels according to the wiring diagrams and
pinout descriptions in this section.
Figure 14
AXW-MLC (/PB) circuit card
connectors, ribbon cable, and
RS-232 4-pin header
Caution
Do not connect power to the
mini-touch panel until the wiring
is complete. If you are using a
12 VDC power supply, apply
power to the mini-touch panel
only after installation is
complete.
Figure 15
Wiring guidelines
Summary of Contents for AXM-MLC
