Allied Telesis x530L Series, Installation Manual

Page: 95 / 228

x530L Series Installation Guide for Virtual Chassis Stacking
95
Choosing a Site for the Switch
Observe these requirements when planning the installation of the switch.

Before installing the switch in an equipment rack, check that the
rack is safely secured so that it will not tip over. Devices in a rack
should be installed starting at the bottom, with the heavier devices
near the bottom of the rack.

Before installing the switch on a table, check that the table is level
and stable.

The power outlets should be located near the switch and be easily
accessible.

The site should allow for easy access to the ports on the front of
the switch, so that you can easily connect and disconnect cables,
and view the port LEDs.

The site should allow for adequate air flow around the unit and
through the cooling vents on the front and rear panels. (The
ventilation direction is from front to back.)

The site must not expose the switch to moisture or water.

The site must be a dust-free environment.

The site must have dedicated power circuits or power conditioners
to supply reliable electrical power to the network devices.

Do not install the switch in a wiring or utility box because it might
overheat and fail from inadequate air flow.
Warning
Switches should not be stacked on a table or desktop. They could
present a physical safety hazard if you need to move or replace
switches.
 E91