Alcatel Vacuum Technology Adixen ATH 1300 M, User Manual

Page: 56 / 122

B 80
2/7
GB 00738 - Edition 10 - Januar
y 03
Alcatel Vacuum Technology France - User’s Manual ATH 1300 M/MT - ATH 1600 M/MT
INPUTS / OU
TPUTS
DRY CONTAC
TS
PUMP CABLE
REM.
RS 232
MODEM
RS 232
B 80
Electrical connection
Controller installation
Connections
The unit must be installed in an environment ventilated
either by natural convection or by the movement of forced
air. Cooling is normally performed by an internal fan which
ventilates air from the inside to the outside of the unit.
Connect the controller to the power supply
using the cable supplied.
(Main with ground connection).
Connect the controller to the pump using the
cable ordered.
Make various connections if dry
inputs/outputs are used
(see B 91 ).
Connect the RS232
serial link cable to the connector
(cable supplied by customer).
(see B 110 and B 120) .
Delayed fuses (x2) located below
the controller:
16A - T - 250V
(see F 10 ).
Electrical grounding of controller
frame (M5) for EMC accordance.
Connect the
RS 485
serial link to
this connector
(see B 100)
.
Analog output is available on this
connector
(see B 100)
.
Connect the connector with
2 squares and 2 screws M3.
Some output contacts are avai-
lable on terminal
DRY CONTACTS (see B 90 ).
Not used
Secure manually
the
2
assembling
screws.
Make sure that:
- the openings on the bottom, top and rear of the unit are
not blocked;
- the ambient temperature does not exceed 50°C;
- a free space of at least 15 mm is left behind,
above and below the unit;
- the controller location is at a height between
64.5’’ and 11’’ from the floor.
CAUTION!
WARNING
HAZARDOUS VOLTAGE ENCLOSED
Danger risk of electric shock, disconnect main
power source and heater power. (if heater
is used, max 110/230 V, 300 VA, 50/60 Hz).
Prior to servicing and wait 5 minutes before
working on this equipment.