66
•
If you are trying to test the Close Call feature with
a nearby transmitter and you do not talk into the
transmitter, the scanner will detect this as data
and will skip the frequency when Data Skip is on.
•
Turn the feature off or talk into the transmitter.
•
The default for this feature is ON.
Setting the Delay Time
SRCH/CLOCALL OPT
E
SET DELAY TIME
E
This setting determines how long the scanner waits after a
transmission ends before resuming quick search, service
search or Close Call operation.
•
Select your setting, then press
E
.
OFF
The scanner resumes immediately when the
transmission ends.
1-5 SEC
The scanner waits the set amount of time after the
transmission ends before resuming.
Note:
The default setting is 2 seconds.
Setting the Search Frequency Step
SRCH/CLOCALL OPT
E
SET STEP
E
This setting selects the frequency step used for setting the
channels.
•
Select your setting, then press
E
.
AUTO
The step is based on the band (see the table at the
front of the manual)
5.0 kHz, 6.25 kHz, 7.5 kHz, 8.33 kHz, 10.0 kHz, 12.5kHz,
15.0 kHz, 20.0 kHz, 25.0 kHz, 50.0 kHz, 100.0 kHz:
The scanner uses the selected step.
Note:
The scanner defaults to AUTO.
Care and Maintenance
General Use
•
Turn the scanner off before disconnecting the
power.
•
Always write down the programmed frequencies in
•
the event of memory loss.
•
If memory is lost, simply reprogram each channel.
•
Always press each button firmly until you hear the
