Afag GE-25-P, Assembly And Operating Instructions Manual

Page: 9 / 48

Safety instructions
Assembly instructions EN

GE-25-P

Date 02.11.2021

Version 1.0 9–48
2.3 Foreseeable misuse
Any use other than or beyond the intended use described above is considered
a misuse of the GE-25-P.
Especially the following use is considered a misuse:

The use of the module as a pressing tool, punching tool, lifting tool, guiding
aid, cutting tool, clamping device or drilling tool.
The GE-25-P must not be exposed to corrosive media. Products for special
environmental conditions are excluded.
Risks can occur if the module is not used as intended. In the event of
damages caused by improper use the following shall apply:

the operating company shall be solely responsible for such damage, and

Afag does not accept any liability for damage caused by improper use.
2.4 Obligations of the operator and the personnel
2.4.1 Observe the assembly instructions
A basic prerequisite for safe and proper handling of the electric gripper is a good
knowledge of the basic safety instructions.
These assembly instructions, in particular the safety instructions contained
therein, must be observed by all persons working with the electric gripper.
2.4.2 Obligations of the operating company
In addition to the safety instructions given in this manual, the operating company
must comply with the safety, accident prevention and environmental protection
regulations valid for the field of application of the electric gripper. The operating
company is required to allow only persons to work on the GE-25-P who:

have the necessary professional qualifications and experience,

are familiar with the basic rules regarding occupational safety and accident
prevention,

have been instructed in the correct handling of the GE-25-P,

have read and understood these assembly instructions.
WARNING
Risk of injury if the module is not used as intended!
The improper use of the module poses a potential hazard to the personnel.

The module may only be used in a technically perfect condition in
accordance with its intended use and the instructions in this manual as well
as in compliance with the safety requirements!

Any malfunctions, particularly those that could impair safety, must be
eliminated immediately!