Safety instructions
12 – 48
Assembly instructions EN
GE-25-P
Date 02.11.2021
Version 1.0
2.7 Changes and modifications
No changes may be made to the GE-25-P which have not been described in
these assembly instructions or approved in writing by Afag. Conversions,
modifications and reworking (e.g. additional threads, drill holes, etc.) can impair
function or safety or cause damage to the GE-25-P.
Afag Automation AG accepts no liability for unauthorised changes or improper
assembly, installation, commissioning, maintenance or repair work.
The electric gripper may not be changed or modified in any way, except with
the prior written consent of Afag Automation AG.
2.8 General hazards / residual Risks
Despite the safe design of the machine and the technical protective measures
taken, there still remain residual risks that cannot be avoided and which present
a non-obvious residual risk when operating the modules.
Observe the safety instructions in this chapter and in the other sections of this
manual to avoid damage to property and dangerous situations for the personnel.
2.8.1 General hazards at the workplace
The electric gripper has been built according to the state-of-the-art and the
applicable health and safety requirements. However, improper use of the
electric gripper may cause the following hazards to the personnel:
danger to life and limb of the operator or third parties,
to the GE-25-P itself,
property damage.
Always keep the assembly instructions ready at hand at the workplace!
Please, also observe:
the general and local regulations on accident prevention and environmental
protection,
the safety information sheet for the electric gripper.
WARNING
Danger - Do not use the GE-25-P in unsuitable environment!
Incorrect ambient and operating conditions can cause hazards from the GE-
25-P that can lead to serious injuries and considerable damage to property or
reduce the service life of the modules.
Ensure that the GE-25-P is only used within the defined application
parameters (
Technical data)
.
